Instructions for use and maintenance of baby hairdresser
Posted by Admin | 11 Nov
instructions Shave the whole hair 1. Install appropriate combs (3mm-6mm, 9mm-12mm) as required 2. Keep the bottom of the comb close to the scalp and push it from the four sides to the top of the head. 3. Repeated shaving can achieve even shaving. 4. Alternate shaving without residual hair. Hairline after repair When using a 12mm comb, use a 9mm comb at the hairline after trimming; When using a 6mm comb, use a 3mm comb at the hairline after trimming. Trimmed hair border 1. Remove the comb, gently contact the front end of the blade with the skin, and slowly push it in the direction of the arrow. 2. Press your ear with your hand, and it is easy to shave. 3. The two ends of the blade are arc shaped and safe to use. Shaving and sideburns Push the knife at right angles to shave. Care The hairdresser uses a high speed low-noise motor and a high strength spring. If it is used for the first time or has not been used for a long time, please remove the cutter head before using it and slide it left and right several times by hand to ensure the elasticity of the spring. The fixed blade is made of special steel. The movable blade includes high-density steel blade and ceramic blade. Before and after use, remember to inject two or three drops of oil between the fixed and movable blades to maintain the long-term sharpness of the blade and prevent heating. Cleaning and maintenance of blade Take the pusher with the front side of the body facing up, and push the cutter head away with both thumbs. Clean the blade assembly with a cleaning brush, and press the cleaning rod to open the blade to remove the hair scraps clamped between the blades. Drop two or three drops of oil to lubricate between fixed and movable blades. Clean and lubricate the blade after several uses. When installing the cutter head, please turn the back of the machine body upward, put the bottom of the cutter head into the slot first, and push the cutter head until it makes a clatter.